Labels:text | font | screenshot | black and white | document OCR: ICOM IC-2710 MAXIMUM SUPPORTED FREQUENCY RANGES: · VHF, 118-135.995 MHZ Rx, 136-174 MHz Tx & Rx · UHF, 320-399.995 MHZ Rx, 400-479 MHz Tx & RX . UHF, 849-869 MHZ & 894-950 MHz Rx See product literature for frequency limits from factory. Please note, these are the "tunable" frequency ranges only. The receivers are optimized over 20-30 MHz ranges which have been centered around the ham bands at the factory. Performance outside the ranges defined in the product specification is not guaranteed. AM / FM MODE SELECTION_(118-135.995 MHz or 320-399.995 MHz Rx only): . Select an appropriate frequency (left side display only) . Push and hold the left side MONI(SQL) switch for about ONE second to toggle AM mode ON or OFF. . The symbol "<" appears to the right of the frequency when AM mode is enabled CROSS BAND REPEATER MODE: . First, verify D-139 Is not present, then To Enter Cross Band Mode: . Set the desired frequency, tone, & offset on both bands . Press [VHF] and [UHF] main knobs and the [SET] key at the same time (An "L" will appear on the display) For zero hang lime, also press the [LOW] key with the above three key command. To EXIT Cross Band Mode: . Press [SET] to exit Cross Band Mode REQUENCY RANGE MODIFICATIONS: . Remove Power and Antenna Leads 181 . Remove the bottom cover of the radio (see Section 16, Page 65 of instruction manual). 0 0133 D15: Viewing the bottom of the radio, orient the chassis with the fan to the right (front of radio to the left) . Refer to the drawing and locate the identified components on the main board in the lower left of the radio D139- D138 TO ENABLE RECEIVE ON ALL 4 013 SUPPORTED FREQUENCIES: . Cut Jumper "W-18" TO ENABLE ONLY SOME Rx FREQUENCIES: J8 Front of Radio · Remove D-134 to enable receive Connector on 300 & 800 MHz frequencies, or · Remove D-132 to enable receive to Front only 300 MHz frequencies Pane Display F16 TO ENABLE EXTENDED TRANSMIT RANGES: . For extended VHF Tx range, Remove D-135 For extended UHF Tx range, Remove D-136 Note: NOT all components shown will be installed Bottom View
